Quality Policy

It is the policy of D & H Engineering to maintain a Quality Control & Assurance System, which confirms to BS EN ISO 9001 and any other similar Quality Systems.

The purpose of this document, based on BS EN ISO 9001, is to show how D & H Engineering’s Quality Procedures and Systems are co-ordinated and controlled. All personnel within the Company are made aware of their own particular fields of responsibility to ensure that the Standards laid down in this document are maintained, and is totally supported by the management of the company.

The Standard Quality System and Practices operated by the Company are as laid down in this Quality Manual.  Where a Client Specification Requirements exceed these Standards they will take precedence except when this would result in the product being unfit for service or unsafe, in which case the matter will be referred to the Client for resolution.

As part of the Company’s commitment to continual improvement, quality objectives will be introduced as deemed necessary.

This is a living document in daily use and will be up-dated at appropriate times to reflect any changes, which may subsequently occur. The Company, therefore, reserves the right to amend it as required.